PLANET FGSD-1022 - Manual (Page 8)


The previous command would apply the follow settings for the Switch.
IP: 192.168.1.100
Subnet Mask: 255.255.255.0
Gateway: 192.168.1.1
Figure 5-2 Set IP address screen
5. Repeat Step 1 to check if the IP address is changed.
n Store current switch configuration
6. On “Switch(config)#” prompt, enter the following command and press
<Enter>.
Switch(config)# copy running-config startup-config
If the IP is successfully configured, the Managed Switch will apply the new IP
address setting immediately. You can access the Web interface of the Managed
Switch through the new IP address.
Note
If you do not familiar with console command or the related param-
eter, enter “help” anytime in console to get the help description.