PLANET MGSD-10080F - Manual (Page 10)

10

Configure IP address
3. On “Switch/>” prompt, enter the following command and press <Enter> as
shown in Figure 6-2.
Switch/> ip setup 192.168.1.100 255.255.255.0 192.168.1.1
The previous command would apply the following settings for the Switch.
IP Address: 192.168.1.100
Subnet Mask: 255.255.255.0
Gateway: 192.168.1.1
Figure 6-2: Setting IP Address
4. Repeat Step 1 to check if the IP address is changed.
If the IP is successfully configured, the Managed Switch will apply the new IP
address setting immediately. You can access the Web interface of the Managed
Switch through the new IP address.
Note
If you are not familiar with console command or the related param-
eter, enter “help” anytime in console to get the help description.