PLANET WGSD-1022C - Manual (Page 8)


5. Start Web Management
The Switch can be fully managed by console. It also provides a convenient Web
management interface for remote management. This chapter guides the quick
access to the Web Management Interface of the Switch.
Since Web Management Interface can be accessed by Ethernet connection, the
administrator workstation must be in the same IP segment as the Switch.
For example, if you do not change the default IP address of the Switch, say
192.168.0.100, you must set the IP address of your administrator workstation to
be 192.168.0.x (where x is a number between 1 and 254, except 100) with subnet
mask is 255.255.255.0.
Then use the Internet browser (Internet Explorer 5.0 or above), and go to
http://192.168.0.100. Enter the default username “admin” default password
“admin” for login, and the main screen as figure 5-1 appears.
Default IP Address: 192.168.0.100
Default Username and Password: admin
Note
The following screen based on WGSW-2840, for other Layer 2
Management Switch that mentioned in chapter 1, the display will
be the same to WGSW-2840.
Figure 5-1 Web Main Screen of the Switch
You can either manage the Switch through the Web interface or through the
console. Please also refer to the user’s manual in the CD-ROM for more information
about the Switch and the management.