PLANET EPN-102 - Manual (Page 2)

-2-
Hardware Installation
Please connect the ONU to you devices as follow:
„ Connecting the RJ-45 network cable.
a. Plug-in the RJ-45 cable to 10/100/1000 GE Port
(EPN-102 only) or 10/100 FE Ports.
b. Plug-in the other side to your host or devices.
„ Connecting the fiber cable.
Before connecting, please note:
‹
Keep the optical connector and the optical fiber clean.
‹ Make sure the bending diameter of the fiber is more
than 6cm.Otherwise; the optical signal loss may be
increased.
‹ Cover a protective cap to guard against dust and water
when the fiber is not used.
a. Remove the protective cap of the optical fiber.
b. Remove the protective cap of the ONU optical
interface (PON interface). Insert the fiber into the
PON interface.
„ Connecting Power Adapter.
a. Connect the power adapter to the power socket
on the ONU.
b. Insert the other end into a power outlet.
c. Turn on the power-switch.