PLANET POE-150 - Manual (Page 12)

8 9
G
Hint
1. Please check the power requirement of
the device that is going to get the power
from POE-150S. If the power require-
ment is higher than POE-150/150S can
supply, current overload will shutdown
the POE-150S itself. Those will shut-
down your device as well.
POE-150 and POE-150S can be installed in pair. However, the
use of third-party device is allowed if the device complied with
802.3af.
4.2 POE-150, the Injector installation
1. Connect a standard network cable from Hub/Switch to
“Ethernet” port of POE-150.
2. Connect the long cable that will be used to connect to
the remote device to the port “Ethernet + DC”.
3. In the other end of the cable, place the paster to the RJ-
45 cable as the figure below.
4. Connect the AC adapter to “48V DC” of POE-150. The
power LED will be steady on.
Figure 3: Warning paster location
4.3 POE-150S, the Splitter installation
1. Connect a standard network cable from “Ethernet+DC”
of POE-150 to “Ethernet+DC” of POE-150S. The POE