PLANET VC-201A - Manual (Page 22)

22
3.2 Connecting VC-201A / VC-202A / VC-204
3.2.1 Connecting Standalone PC
Refer to the following procedures to setup the VC-201A to a
standalone PC.
1. Set the VC-201A to be CO or CPE mode from the DIP switch
at the rear panel.
2. Power on the VC-201A by connecting its power source.
3. Power LED will illuminate.
4. Connect VDSL line from another VDSL device to VDSL port of
the VC-201A.
5. LNK LED will blink to illuminate.
6. Connect telephone to the PHONE port.
7. Connect Ethernet port to PC Network Interface Card (NIC) via
regular Cat. 5, 5e or 6 cable.
VC-201A
VDSL
Phone
Phone
RJ-11 Phone Jack
RJ-45
Cat.5 Twisted Pair Cable
RJ-11 Line Cord
RJ-11 Line Cord
TP
Figure 3-4: Connecting Standalone PC