PLANET VC-201A - Manual (Page 24)

24
3.3 Connecting VC-202A
3.3.1 Connecting Standalone IP Device
Refer to the following procedures to setup the VC-202A to a
standalone PC.
1. Set the VC-202A to be CO or CPE mode from the DIP switch
at the rear panel.
2. Power on the VC-202A by connecting its power source.
3. Power LED will illuminate.
4. Connect coaxial cable from another VDSL device to VDSL BNC
port of the VC-202A.
5. LNK LED will blink for illuminating.
6. Connect Ethernet port to Ethernet device via regular Cat. 5,
5e or 6 cables.
VC-202A
VDSL
BNC
IP Camera
RG58 Jack
RJ-45
Cat.5 Twisted Pair Cable
RG58 / RG6
TP
VDSL2
100Base-TX UTP
VDSL2 Coaxial Cable VDSL2
Figure 3-6: Connecting Standalone IP Device