PLANET MC-1600MR - Manual (Page 14)

- 14 -
The serial port of Web Smart Media Converter Chassis. default setting is set to 19200 baud using a character format of 8
data bits, no parity, and 1 stop bit.
Therefore, configure the terminal or workstation to use these settings before you log on to the Web Smart Media Converter
Chassis. You can change this default setting, if desired, after you log on.
3.2.2 Web Management
You can manage the Web Smart Media Converter Chassis remotely by having a remote host with web browser, such as
Microsoft Internet Explorer or Netscape Navigator.
Using this management method:
The Web Smart Media Converter Chassis must have an Internet Protocol (IP) address accessible for the remote host.
3.3 Assigning an IP Address to the Web Smart Media Converter Chassis
To manage the Web Smart Media Converter Chassis remotely through the web browser with a Management Station, you
must assign an IP address to the Web Smart Media Converter Chassis.
To set the IP address, please use “set ip xxx.xxx.xxx.xxx mmm.mmm.mmm.mmm ggg.ggg.ggg.ggg” command.
For example, to configure the Web Smart Media Converter Chassis with the following IP settings:
IP Address: 192.168.0.1
Subnet Mask: 255.255.255.0
Default Gateway: 192.168.0.254
Press the following command and press <Enter>
set ip 192.168.0.1 255.255.255.0 192.168.0.254
Then the following message appears under console interface:
The IP sets to 192.168.0.1
The netmask sets to 255.255.255.0
The gateway sets to 192.168.0.254
You can access the web interface of Web Smart Media Converter Chassis through the new IP address.