PLANET MC-1600MR User Manual
Page 24
- 24 -
4.4.3.1 Set slot [n]
This command allows configuring per slot parameters of Web Smart Media Converter Chassis, different parameters pro-
vide on FST-8 / GST-7 Media Converter boards installation. The correct usage is shown as below:
Set slot [n]: n=1-16
, to configuring per slot parameters of Web Smart Media Converter Chassis. The configuring per
slot parameters screen in
Figure 4-14
appears and the detail description shown in
table 4-2 &
4-3
.
Figure 4-14
Set slot [n] command screen
Item
Description
Device
To enable or disable per FST-80x Converter board.
LLCF
To enable or disable the LLCF function from FST-80x Converter board.
TP AN Mode
To set the UTP port runs at Auto-negotiation or Forced Mode.
TP Speed.
＊
To set the UTP port runs at 100Mbps or 10Mbps.
TP Duplex.
＊
To set the UTP port runs at Full duplex or Half duplex mode.
TP FC
To set the Flow Control of the UTP port to enable or disable.
Fiber LLR
To enable or disable the LLR function of the Fiber port.
Fiber Duplex
To set the Duplex Mode of Fiber port to Full duplex or Half duplex mode.
Table 4-2
Descriptions of the FST-80x slot Configuration screen Objects
Item
Description
Device
To enable or disable per GST-70x Converter board.
Fiber LLR
To enable or disable the LLR function of the fiber port.
Fiber AN Bypass
To set the Auto negotiation bypass function of the fiber port to enable or disable.
Table 4-3
Descriptions of the GST-70x slot Configuration screen Objects
#
Notice:
＊:
Only set the TP port run at force mode, the TP speed and TP duplex function are available.