PLANET VF-402-KIT - Manual (Page 16)

16
(7) The relation of the video of optical transmitter and optical receiver is
one-to-one, which means V1~V4 of optical transmitter is one-to-one to V1~V4
of optical receiver.
3.3 Order for installation
(1) Connect the interface of optical transmitter with camera or speed dome. Then
connect the optical fiber and the power supply.
(2) Connect the interface of optical receiver with video interface, monitor, video
matrix and displayer. Then connect the optical fiber and the power supply.
(3) Insert the power supply according to the configuration of device, correctly
access peripheral attachment. Check optical fiber, data cable, video cable,
and etc. on the basis of wiring diagram (accompanied with each set of optical
transceiver) of optical transceiver.
(4) After all the connection and passing inspection, power on to see if device run
normally.
(5) Please install the lightning protection facilities and make sure the ground
connection is good when installing this device in the open air.