PLANET VRT-420N - Manual (Page 48)

Add Bandwidth Management Group Rules
Click on [Add] tab. You will see the following screen.
Configure [Add SBM] Settings following the instructions below.
Sequence Number This defines the sequence of the SBM rules. If a packet fits the conditions set
by the SBM rules, the packet will then be sorted according to the first SBM rule
from the top of the list.
Rule Name Name of the SBM rule.
Rule Enable Enable/Disable this SBM rule
Internal IP Set up the internal IP for this SBM rule.
Protocol Set up the protocol (TCP or UDP) for the ACL to be enabled.
Service Port Range Set up the Service Port Range (e.g., HTTP is TCP/80) for the SBM to be
enabled.
External Interface Choice the interface for this SBM rule, WAN 1/ WAN2.
Bandwidth Allocation By Ratio, by Bandwidth or by pre-defined Group rules
Ratio The ratios of the whole upload bandwidth according to the External Interface.
Utilize Bandwidth More
than Guaranteed
Check this box if you wish to allow the traffic confirming this SBM rule to be
able to utilize the whole bandwidth when the bandwidth is idle.
48