PLANET WAP-6200 - Manual (Page 27)

27
attribute to be larger than the maximum MSDU (MAC Service
Data Unit) size TURNS OFF the RTS/CTS handshake. Set this
attribute to ZERO TURNS ON the RTS/CTS handshake. Enter a
value between 0 and 2347.
Beacon Interval The Beacon Interval value indicates the frequency interval of the
beacon. Enter a value between 20 and 1024. A beacon is a
packet broadcast by the Router to synchronize the wireless
network.
Data Rate Select the transmission data rate from pull-down menu. Data
rate can be auto-select, 11M, 5.5M, 2M or 1Mbps.
Preamble Type Click to select the Long Preamble or Short Preamble support
on the wireless data packet transmission.
Broadcast SSID Click to enable or disable the SSID broadcast function.
IAPP
Click to enable or disable the IAPP function.
802.11g
protection
Protect 802.11b user.
RF Output Power To adjust transmission power level.
Turbo Mode
Click to Enable/Disable turbo mode.(Only apply to WLAN IC of
Realtek).
Block Relay
Between Clients Click Enabled/Disabled to decide if blocking relay packets
between clients.
WMM Click Enabled/Disabled to init WMM feature.
ACK Timeout Set ACK timeout value. It shows current time in the end.
After changing the configuration setting, please click the “Apply Changes” button to
complete the new configuration setting. Otherwise, click the “Reset” button to abort
change and recover the previous configuration setting.