PLANET CAM-IVP55 - Manual

– 1 – – 2 –
– 3 – – 4 –
1. Safety Precautions
1. Please do not directly touch the sensor element. If
necessary, use a soft cloth moistened with alcohol to
wipe off any dust.
2. Please be extra careful not to shake the camera.
3. Please avoid places where there is direct sunlight.
4. When the camera is not in use, keep the lens or the lens
cap attached to protect the sensor.
5. Don’t attempt to service this unit yourself unless you are
authorized to do so. This may exposure you to dangerous
voltage or other hazards. Refer all servicing to qualified
personnel only.
6. Please don’t use the camera under the following
abominable environments. Temperature is lower than
-10 degrees Centigrade, or is higher than +50 degrees
Centigrade.
2. Package Contents
 CAM-IVP55 / CAM-IVP55V
 1 x Quick Installation Guide
 1 x Wrench
 1 x Waterproof Cable Connector
 1 x Screw Kit
3. Overview
Power Input
Video Output
Connector Definition
Connector Description
Power Input Connect to a DC 12V power adapter.
Video Output BNC connector for analog video output.
4. Product Specification
General
Model
CAM-IVP55 CAM-IVP55V
Image pick-up device 1/3" Color Sony Exview HAD CCD II
Effective Pixels
NTSC: 976 x 494, PAL: 976 x 582
Horizontal Resolution Color: 650 TVL, B / W: 700 TVL
Lens Board Lens 3.6mm
Vari-Focal Lens with ICR
3.7~12mm / F1.6
Min. Illuminator 0.01 Lux ([email protected]) Day Mode
Auto Electronic Shutter NTSC: 1/60s~1/100,000s, PAL: 1/50s~1/110,000s
S/N Ratio
More than 48 dB
Gamma Characteristic 0.45
White Balance
Auto / Indoor / Outdoor / Manual / Push Auto
Gain Control Auto
Back Light Comp. On / Off
Synchronous System Internal
Video Output Composite 1.0 Vp-p, 75 ohm
View Angle H: 21~68 Degree, V: 16 -54 Degree
IR LED 24 pieces
IR Wavelength 850 nm
IR Distance 20~25 meters
Vandal Resistant 10 pounds
Water Resistant IP-66
Environment
Power Requirement
DC 12V
IR on: 380mA max. /
IR off: 90mA max.
DC 12V
IR on: 410mA max. /
IR off: 120mA max.
Dimensions 145 x 110 mm (Φ x H)
Weight 1.03 kg
Operating Temperature -10 ~ 50 Degree C
5. Physical Installation
1. Use the provided wrench to loose the tamper-resistant
housing cover with screws still attached on the cover.
Note
During the installation, please take care and
avoid crash. That may cause people hurt and
this device damage.
2. Set the mounting base onto the wall or ceiling and
center it over the mounting hole, using the supplied four
retaining screws to secure the main body.
3. Set proper image by moving the camera module and set
the focus by turning the lens to the left or right direction.