PLANET CAM-IVP55 - Manual (Page 2)

– 5 – – 6 –
4. When the camera focus adjustment has been completed,
use the provided wrench to fasten the tamper-resistant
housing to the main body.
5. Besides the waterproof connector, when using the side
conduit cabling, it is suggested to cover the cables
using metal covers (to prevent external damage and
for waterproof prevention), and wined the waterproof
adhesive tape onto the metal cover before installation.
6. Connect the video output to the monitor or other video
device through a 75 Ohm type coaxial cable and the
DC-Jack to the power source.
Note
Please make sure the power output voltage is
DC 12V (max. ±10%). We suggest using a DC
12V switching power adapter which can provide
a stable power output.
6. DIP Switch Setting
• Flickerless Function
Set switch-OFF / F.L. to Flicker to enable flickerless
function, in this mode, the switch-AES / OFF is auto
disabled.
• AGC-Hi / AGC-Lo Function
Adjust the switch to AGC indicates AGC-Hi and OFF
indicates AGC-Low. AGC-Hi mode--The maximum AGC
gain is approximately 26dB. AGC-Lo mode--The maximum
AGC gain is approximately 16dB.
• Auto Iris Function
When using an auto iris lens, the switch-AES / OFF
should be in the OFF position to disable the AES function.
Adjust VR to the proper level.
• BLC Function
Set switch-OFF / BLC to BLC to enable Back Light
Compensation (BLC) function.