ProSoft Technology MVI69-ADMNET - Manual (Page 45)

MVI-ADMNET ♦ 'C' Programmable Setting Up Your Development Environment
'C' Programmable Application Development Module with Ethernet Developer's Guide
ProSoft Technology, Inc. Page 45 of 122
February 20, 2013
3.6.3 Enabling the Console
Before you can use RY and SY from the command prompt, you must enable the
console in the ADM module’s BIOS.
To change BIOS settings
1 Remove the module from the rack and install the Setup jumper.
2 Return the module to the rack.
3 Connect to the module using HyperTerminal at 19,200 bps, and then cycle
power to reboot the module.