ProSoft Technology MVI71-GEC - Manual (Page 13)

MVI71-GEC ♦ PLC 5 Platform Start Here
Generic ASCII Ethernet Communication Module User Manual
ProSoft Technology, Inc. Page 13 of 86
May 11, 2011
1.4 Install the Module in the Rack
If you have not already installed and configured your PLC processor and power
supply, please do so before installing the MVI71-GEC module. Refer to your
Rockwell Automation product documentation for installation instructions.
Warning: You must follow all safety instructions when installing this or any other electronic
devices. Failure to follow safety procedures could result in damage to hardware or data, or even
serious injury or death to personnel. Refer to the documentation for each device you plan to
connect to verify that suitable safety procedures are in place before installing or servicing the
device.
After you have checked the placement of the jumpers, insert MVI71-GEC into the
PLC™ chassis. Use the same technique recommended by Rockwell Automation
to remove and install PLC modules.
Warning: This module is not hot-swappable! Always remove power from the rack before
inserting or removing this module, or damage may result to the module, the processor, or other
connected devices.
1 Turn power OFF.
2 Align the module with the top and bottom guides, and slide it into the rack
until the module is firmly against the backplane connector.