ProSoft Technology 5201-DFNT-ASCII - Manual (Page 23)

ASCII Protocol Configuration ASCII ♦ ProLinx Standalone
Generic ASCII Serial Communication Module
ProSoft Technology, Inc. Page 23 of 40
July 7, 2008
4.1.20 Tx Minimum Delay
0 to 65535
This parameter specifies the minimum number of milliseconds to delay before
transmitting a message out the port. This pre-send delay is applied before the
RTS on time. This may be required when communicating with slow devices.
4.1.21 Swap Tx Data Bytes
Yes or No
This parameter determines if the data to be transmitted by the module will have
the byte order of the data swapped. If the parameter is set to No, no byte
swapping will occur. If the parameter is set to Yes, the odd byte will be swapped
with the even byte in each word of data received.