Nikon Coolpix A300 User Manual
Page 158
143
Error Messages
No access.
The camera could not receive the signal from the
smart device. Wirelessly connect the camera and
smart device again.
• Touch an NFC-compatible smart device to the
camera.
• Select Connect to smart device in the
network menu.
Wi-Fi connection
terminated.
The Wi-Fi connection is terminated in the
following situations:
• Poor connectivity.
• The battery level is low.
• A cable or a memory card is inserted or
removed.
Use a sufficiently charged battery, disconnect the
TV, computer or printer and establish the wireless
connection again.
Turn the camera off and
then on again.
If the error persists, contact your retailer or Nikon-
authorized service representative.
Communications error
An error occurred while communicating with the
printer.
Turn the camera off and reconnect the USB cable.
System error
An error occurred in the camera’s internal
circuitry.
Turn the camera off, remove and reinsert the
battery, and turn the camera on. If the error
persists, contact your retailer or Nikon-authorized
service representative.
Printer error: check
printer status.
After solving the problem, select Resume and
press the
k button to resume printing.*
–
Printer error: check
paper.
Load the specified size of paper, select Resume,
and press the
k button to resume printing.*
–
Printer error: paper jam.
Remove the jammed paper, select Resume, and
press the
k button to resume printing.*
–
Display
Cause/Solution
A