Canon PowerShot SX720 HS - Manual (Page 86)

86
Before Use
Basic Guide
Advanced Guide
Index
Camera Basics
Auto Mode /
Hybrid Auto Mode
Other Shooting Modes
P Mode
Tv, Av, and M Mode
Playback Mode
Wi-Fi Functions
Setting Menu
Accessories
Appendix
Adjusting the Flash Output
Still Images Movies
Choose from the three flash levels in [ ] mode.
1
Enter [ ] mode.
● Set the mode dial to [ ].
2
Configure the setting.
● Press the [ ] button, choose [ ] in the
menu, and adjust the setting by either
pressing the [ ][ ] buttons or turning
the [ ] dial (= 28).
● Once the setting is complete, the flash
output level is displayed.
[ ]: Minimum, [ ]: Medium,
[ ]: Maximum
● You can also set the flash level by accessing MENU (= 29)
and choosing [
] tab > [Flash Settings] > [Flash Output].
● You can set the flash level in [ ] or [ ] mode by accessing
MENU (= 29) and choosing [ ] tab > [Flash Settings] >
[Flash Mode] > [Manual].
● You can also access the [Flash Settings] screen (= 29)
when the flash is up by pressing the [ ] button and immediately
pressing the [
] button.
● After you set the shutter speed and aperture value, the exposure
level may change if you adjust the zoom or recompose the shot.
● Screen brightness may change depending on your specified
shutter speed and aperture value. However, screen brightness
remains the same when the flash is up and the mode is set to [ ].
● To have the setting that is not chosen in step 2 (whether shutter
speed or aperture value) automatically adjusted to obtain
standard exposure, hold the shutter button halfway and press the
[ ] button. Note that standard exposure may not be possible with
some settings.
● With shutter speed of 1.3 seconds or slower, ISO speed is fixed
at [80].
● [ ] Auto mode cannot be used in [ ] mode.
● [ ]: Manual
● Calculation of standard exposure is based on the specified
metering method (= 71).