Canon EOS 1D X Mark II - Manual (Page 132)

132
Responding to Error Messages
 Are the transmitter and the access point set to use the same
encryption method?
 The transmitter supports the following encryption methods: WEP,
TKIP, and AES (p.27).
 If filtering by MAC address is active, is the MAC address of the
transmitter used registered at the access point?
 Register the MAC address (p.116) of the transmitter used at the
access point.
 Did you hold down the access point’s WPS (Wi-Fi Protected
Setup) button for the specified period of time?
 Hold down the WPS button for the period of time instructed by the
access point’s instruction manual.
 Are you trying to establish a connection near the access
point?
 Try establishing the connection when both devices are within reach
of each other.
 Connection is in progress by other access points in
Pushbutton Connection mode (PBC mode) of Wi-Fi Protected
Setup (WPS).
 Wait a while before trying to establish the connection, or try to
establish a connection in PIN code connection mode (PIN mode)
(p.29).
67: Incorrect wireless LAN encryption method
68: Cannot connect to wireless LAN terminal. Retry
from the beginning.
69: Multiple wireless LAN terminals have been found.
Cannot connect. Retry from the beginning.