Sharp PN-V602 - Manual (Page 16)

16
E
Binding Cables
The cables connected to the terminals on the rear of the monitor can be fastened with the cable clamps.
Insert the cable clamp into the cable clamp attachment on the rear of the monitor and fasten the cables.
: Cable clamp attachment
Cable clamp
Cable
Cable clamp
attachment
Removing the Handles
The handles can be removed.
The removed handles can be attached on the side.
1. Remove the handle screws and remove the handles and
handle spacers.
2. Pass the handle screws through the handles and handle
spacers in order and secure.
Caution
• The handles, handle screws and handle spacers are for
this monitor. Do not use them for any other devices.
• When attaching the handles, always use this monitor’s
handles, handle spacers, and handle screws.
• Be sure the handles are attached securely.
TIPS
• To lower the height of the handles, attach the handles with
the handle spacers removed. To attach the handles with
the handle spacers removed, secure the handles with the
included handle screws (short).
Handle
Handle screws
Handle spacers
Handle spacers
Affixing the Protection Covers
After installing the monitor, affix the protection covers
(4 pieces) as necessary.
Protection cover
Protection cover