Roland TD-02K V-Drums Electronic Drum Kit - Manual (Page 16)

16 16
Configuring the Detailed Settings
Adjusting the Offset of the Hi-Hat (VH-10/VH-11)
1 . With the hi-hat completely separated from
the motion sensor unit, power-on the unit.
motion sensor unit
Separated
clutch screw
2 . Loosen the clutch screw and let the hi-hat
rest naturally on the motion sensor unit.
3 . Press the [MENU] button.
4 . Use the [ Н ] [ Л ] buttons to select “PAD”, and
press the [ENTER] button.
5 . Strike the hi-hat to select the pad.
6 . Use the [ Н ] [ Л ] buttons to select “Type”, and
use the [-] [+] buttons to select the hi-hat
you’re using (VH-10 or VH-11).
PAD HH
Type VH10â
7 . Use the [ Н ] [ Л ] buttons to select “VH Set”,
and press the [ENTER] button.
8 . If the screen
indicates “Turn
screw L”, turn the
offset adjustment
screw counter-clockwise. If the screen
indicates “Turn screw R”, turn it clockwise.
When the value shown in the lower left of the screen is
approximately 80 and the “OK!” indication appears, the
adjustment is complete.
Adjust HH offset
<80> OK![EXIT]
9 . Fasten the clutch screw so that the hi-hat
opens to the amount you prefer.
10 . Press the [ ] (DRUM KIT) button to return
to the DRUM KIT screen.
offset adjustment offset adjustment
screw screw
CLOSE CLOSE OPEN OPEN
Expanding your drum set
Adding a crash cymbal
This example shows the settings to make when a cymbal set
(OP-TD1C, sold separately) is added as the “Crash Cymbal 2”
(CR2) on the TD-02K/TD-02KV.
OP-TD1C added
OP-TD1C settings
1 . Connect “CR2” of the dedicated connection
cable to the CY-5 that you added.
2 . Set the CR2’s PAD Type to “CY5”, and set
“CR2Usage” to “CR2”.
Ø For details, refer to “Making Pad Settings” (p. 14).
This completes settings.
Using a CY-13R in place of the ride cymbal (CY-5)
On the TD-02K/TD-02KV, you can use a CY-13R (sold separately)
in place of the ride cymbal (CY-5). This example shows the
settings when using a cymbal mount (MDY-Standard).
CY-13R used as a
replacement
MDY-Standard
RIDE (CY-13R) settings
1 .
Connect “RD” on the dedicated connection cable
to the BOW/EDGE OUTPUT jack on the CY-13R, and
connect “CR2” on the dedicated connection cable to
the BELL OUTPUT jack.
2 .
Set the RD’s PAD Type to “CY13R”, and set CR2Usage
to “RDB”.
Ø For details , refer to “Making Pad Settings” (p. 14).
This completes settings.