Enviro C-11212 - Manual (Page 21)

21
Secondary Installation
Figure 30: Filler panel with trim installation.
I
NSTALLATION OF
S
URROUND
P
ANEL
:
The Sienna must have one of the panels installed around the unit; the unit panel, the filler panel, or the
filler panel with trim. If you have trim for your filler panel, the trim must be installed before installing the
Figure 29: Screw to
hold the trim against
the surround.
Figure 27: Corner brackets
for trim.
filler panel onto the unit. Only trim kits, surround panels, and faces supplied
by the manufacturer shall be used in the installation of this appliance. Draft
Relief Openings must not be covered or blocked. The flow of combustion
and ventilation air must not be obstructed.
1. Attach one side trim to the top trim using a corner bracket (see Figure
27) to secure pieces together. There are two (2) main pieces to each
corner bracket (see Figure 28). Install these corner pieces into the trim
with the “B FACE” sides facing each other & the screw heads facing
outward. Align the side and top trim tightly together and with a flat
head screwdriver tighten the screw in each corner bracket in the side
trims, then tighten the top trim.
2. Slide the two (2) attached trim pieces
onto the surround panel.
3. Attach the other side trim piece to the
top trim using the same method used
in Step 1.
4. Place the second side of the trim
on the surround panel in the same
manner use on the first side and
secure in the same manner.
5. On the side trims there are holes 2”
(50 mm) from either end. Using a
Phillips screwdriver, place a #8 screw
11⁄4” long in each hole and tighten
(refer to Figure 29). This will keep the
trim tight against the surround.
NOTE: The notch at the bottom of the left trim
is so the power cord can be run to the outside
of the panel.
INSTALLATION: Lift the surround upright in
front of the fireplace with the four (4) hooks
pointing towards the fireplace. Slide the hooks
into their corresponding slots (see Figure 30).
Ensure the hooks are pushed all the way into
the slots and the notch on the hook must be on
the bottom of the slot. The surround should be
wiped with a damp cloth periodically.
REMOVAL: Lift the surround straight up in
order to unhook the notch on the hooks from
the bottom of the slots. Pull the surround out
away from the fireplace. Place the surround
where it will not be damaged.
Figure 28: Two pieces of corner bracket.