5 installing the cable clips, Installing the cable clips -6 – Asus ProArt Display OLED PA32DC 31.5" 4K HDR Monitor User Manual
Page 22
![background image](/files/869069/content/doc022.png)
2-6
Chapter 2: Setup
2.5 Installing the cable clips
Use the cable clips to manage the connected cables.
To install the cable clips:
1.
Using a paperclip (or similar item), remove the rubbers covering the screw
holes (Figure 1).
2.
By aligning the screw hole (marked by
blue
line) and the guide pin (marked
by the
pink
line) of the cable clip with the screw holes, install the clip to its
designated location on the rear of the monitor. Then secure the cable clip
with the screw (Figure 2).
Repeat the same steps to install other cable clips.
•
Make sure the guide pin is installed into the screw hole closer to the
edge of the monitor.
•
The cable clip is divided into two sides (left and right).
3.
Route the connected cables through the installed cable clips (Figure 3).
(Figure 1)
(Figure 2)
(Figure 3)