Before use, Note about pinpoint feet – Teac AP701 Stereo Power Amplifier (Black) User Manual
Page 5
EN
5
V
Placement precautions
o
Place the unit in a stable location near the audio system that will
be used with it.
o
Do not install this unit in a location that could become hot.
This includes places that are exposed to direct sunlight or near
a radiator, heater, stove or other heating equipment. Moreover,
do not place it on top of an amplifier or other equipment that
generates heat. Doing so could cause discoloration, deformation
or malfunction.
Also avoid locations that are subject to vibrations or exposed to
excessive dust, cold or moisture.
o
When installing this unit, leave a little space (at least 3 cm or 1
"
)
between it and walls and other devices in order to allow good
heat dissipation.
If you put it in a rack, for example, leave at least 5 cm (2
"
) open
above and 10 cm (4
"
) open behind it. Failure to provide these
gaps could cause heat to build up inside and result in fire.
o
Do not place CDs, CD-Rs, cassette tapes, other audio equipment
or other items that are susceptible to heat on top of the unit.
Doing so could damage these items.
o
Do not put cloth on top of the unit or place the unit on top of
bedding or thick carpets. Doing so could cause the unit to over-
heat and damage it.
o
Do not move the unit during use.
o
The voltage supplied to the unit should match the voltage
printed on the back of the unit. If you are in any doubt regarding
this matter, consult an electrician.
o
Do not open the body of the unit as this might result in damage
to the circuitry or cause electric shock. If a foreign object should
get into the unit, contact your dealer.
o
When removing the power plug from the wall outlet, always pull
directly on the plug; never yank on the cord.
Before use
Note about pinpoint feet
High-precision metal pinpoint feet are attached to the bottom plate
of this unit.
The pinpoint feet and their stands are loose, but the stands support
the unit when it is placed, effectively dispersing vibrations.
Chassis
Pinpoint foot (metal)
Foot-stand (metal)
Screws that attach
foot-stand
o
The included foot pads are intended to protect the surface
where the unit is placed. Apply them to the bottoms of the foot-
stands to avoid scratching the surface where the unit is placed.