Neumann MT 48 Desktop 12x12 USB-C Audio/MIDI Interface - Manual (Page 23)

MT 48 | 23
Reverb
Every channel has a send to the built-in reverb . Please note that there is only one reverb pro-
cessor for all four mixers . So, the send level in the individual channels is the same in all four
mixers . However, the Reverb has its own output fader . Using the REV fader, the total amount of
reverb can be adjusted in each mixer individually .
Please note that reverb is for monitoring purposes only, i .e . to give singers and musicians
a more inspiring sound in their headphones . Reverb is not recorded, not even in the PostFX
driver channels .
The Reverb parameters can be edited . Press on the REV channel name and select Edit REV:
The controls are similar to what you would find in a plug-in or hardware unit:
LOW CUT 10 Hz … 20 kHz
ROOM SIZE small … large
HIGH CUT 10 Hz … 20 kHz
PREDELAY 0 … 300 ms
DECAY 0 … 100%
DIFFUSION 0 … 100%
Snapshots
EQ, Dynamics, and Reverb each have their own snapshots (presets), which, of course, is par-
ticularly useful for the Reverb: