Neumann MT 48 Desktop 12x12 USB-C Audio/MIDI Interface - Manual (Page 30)

MT 48 | 30
Advanced settings
Output levels
The analog outputs can be switched between high and low level with +24 dBu or +18 dBu @ 0
dBFS . The signal level can be switched for output pairs 1+2 and 3+4 individually .
X Go to MENU → SETTINGS → AUDIO OUTPUTS:
+24 dBu results in slightly better signal-to-noise but may be too hot for some equipment . When
directly connecting your (active) studio loudspeakers, the lower signal level +18 dBu may be
useful to prevent ear blasting SPLs . If needed, you can dial in additional signal attenuation .
Speakers A/B latch mode
When using two sets of speakers, you may want to avoid both speaker pairs playing at the
same .
X Go to MENU → SETTINGS → MONITORING and scroll down to the bottom of the page:
X Activate “MIX 1-2 IN A/B MODE” .
Now you can easily toggle between both speaker pairs . Pressing the SPEAKERS A button
automatically mutes SPEAKERS B and vice versa .