Neumann MT 48 Desktop 12x12 USB-C Audio/MIDI Interface - Manual (Page 26)

MT 48 | 26
There are three buttons on the right-hand side:
• RESET DISPLAY restores the default order (but does not enable or disable strips) .
• ENABLE ALL enables all channel strips .
• SHOW ALL STRIPS displays all strips, including those which are currently hidden (disabled) .
MT 48 status bar
The Status Bar gives an overview over the current state of the MT 48:
48V indicates if phantom power is active on one or more channels .
OV indicates overload in the MT 48 mixer .
CUT numbers + TB (Talkback) in red indicate inputs that are cut
(muted) .
DIN5 symbol indicates MIDI activity .
Fine precision for value changes enabled/disabled .
Network port with flash indicates Power over Ethernet .
Letter symbol lights up when a message or error has been received .
Clock status: A green M indicates the MT 48 is Master; a green S indi-
cates the MT 48 is slave . Yellow color indicates locking is in progress,
red color indicates improper synchronization (check your setup!) .
Optical Input as Clock source: If the optical input is Master, the icon
appears green . Yellow color indicates locking is in progress, red color
indicates improper synchronization (check your setup!) . If the optical
input is not used as Clock source, the icon is colorless .
44 .1/48/88 .2/96/176 .4/192 kHz is the current sampling rate .