Canon PIXMA MG2525 All-in-One Inkjet Printer (Black) - Manual (Page 114)

Changing the Machine Operation Mode
If necessary, switch between various modes of machine operation.
The procedure for configuring Custom Settings is as follows:
1. Make sure that the machine is on, and then select Custom Settings
from the pop-up menu on the Canon IJ Printer Utility
Note
If the computer is unable to communicate with the machine, a message may be
displayed because the computer cannot access the function information that was
set on the machine.
If this happens, click
Cancel to display the most recent settings specified on your
computer.
2. If necessary, complete the following settings:
Ink Drying Wait Time
You can set the length of the machine rest time until printing of the next page begins.
Moving the slider to the right increases the pause time, and moving the slider to the
left decreases the time.
If the paper gets stained because the next page is ejected before the ink on the
printed page dries, increase the ink drying wait time.
Reducing the ink drying wait time speeds up printing.
Align heads manually
Usually, the Print Head Alignment function of Test Print on the pop-up menu in the
Canon IJ Printer Utility is set to automatic head alignment, but you can change it to
manual head alignment.
If the printing results are unsatisfactory even after you execute automatic head
alignment,
execute manual head alignment .
Check this check box to perform the manual head alignment. Uncheck this check box
to perform the automatic head alignment.
3. Apply the settings
Click Apply and when the confirmation message appears, click OK .
The machine operates with the modified settings hereafter.
114