NETGEAR Nighthawk M1 MR1100 AC1000 Wireless Dual-Band Gigabit Mobile Router - Manual (Page 16)

Connect to the Mobile Router Network
You can connect your computers and mobile devices to the mobile router WiFi network.You can also connect
a computer to the mobile router through a tethered connection using the USB cable that came in the package
with the mobile router.
If you set up your computer to use a static IP address, change the settings so that it uses
Dynamic Host Configuration Protocol (DHCP). Note
WiFi Connection
You can find and select the WiFi network or you can connect to the router’s WiFi network with Wi-Fi Protected
Setup (WPS). For information about using WPS, see
Use WPS to Connect to the Mobile Router WiFi Network
on page 51.
To find and connect to the WiFi network:
1. Make sure that the mobile router is powered on (its LED is lit).
2. Check to make sure that WiFi is enabled on your computer or mobile device and search for WiFi networks.
See the following table or the manual for your WiFi-enabled device for further details on searching for
WiFi networks.
Instructions Device
Click the Internet Access icon, which is usually found on the bottom right
side of your screen. Windows
computer
Go to the WiFi menu and select Network. Mac computer
Go to the Settings menu and tap the WiFi icon. Mobile devices
3. Select the WiFi name that is displayed on your mobile router screen.
4. Enter the WiFi password exactly as shown on the mobile router screen.
The password is case-sensitive.
Your computer or mobile device connects to the WiFi network.
Connect to the Mobile Router
16
Nighthawk LTE Mobile Hotspot Router Model MR1100