Blackstar AMPED 2 100W Compact Guitar Amplifier and FX Pedal - Manual (Page 10)

19 18
English
English
Architect
Amplifier
On this page all of the front panel (outlined in the ‘Front Panel’ section of this
manual) controls of your AMPED 2 can be adjusted.
To switch to CabRig page in Architect, click on the CabRig icon at the bottom of
the page. Please see the CabRig section below for more information on CabRig.
Local Patches
Click on the ‘Save’ icon in the toolbar to save a Local Patch. All of the front panel
settings will be saved in a Local Patch. Local Patch can be recalled by double
clicking on the relevant patch in the Patches panel.
NOTE: Local Patches cannot be saved to your amp. They can only be recalled
and loaded to your amp when connected to Blackstar’s Architect.
Random Preset Generation
Click on the ‘Die’ icon to generate a random amp preset. All front panel controls
will be randomised.
Audio Settings
Click on the ‘Audio Settings’ icon to open the Audio Settings panel.
Adjust detailed Delay and Modulation settings, Fuzz Bias, Presence, MIDI channel,
FX Loop and Reverb settings here. Changes made here will automatically update,
but will not be permanently saved to the amp. To save your changes, click “Save
Amp Settings” at the bottom of the page.
Tuner
Click on the ‘Tuner’ icon or the screen to activate the Tuner. The behaviour of the
Tuner is the same as outlined in the Tuner section (14).
NOTE: The “Wide” setting will enhance and widen the stereo image, resulting in
an expansive stereo experience.