Epson 1640XL - Manual (Page 37)

2
Setting Up the Scanner 2-15
R4C5460
Rev. C
A5 size SETUP.FM
12/4/00 Pass 3
R Proof Sign-off:
C.Fujiwara
_______
M.Fujimori _______
J.Hoadley _______
Connecting the scanner
To connect the scanner to your computer or USB hub:
1. Connect one end of the cable (Type B) to the USB port on the
back of the scanner.
2. Connect the other end of the cable (Type A) to the USB port
on your computer, or USB hub.
Note:
❏ USB cables enable you to connect the scanner whether your
computer is on or off. If you connect the scanner while your
computer is on, the “Add New Hardware Wizard” dialog box
(Windows) or a message telling you that the scanner driver needs
to be installed (Macintosh) will appear. When this happens, follow
the instructions in Chapter 3, then install the software.
❏ Connect the USB cable to your computer, then install or start the
scanner software. Do not connect or disconnect the USB cable while
the scanner software is open.
❏ Make sure no other interface is used.