Enterasys Networks X-Pedition XSR CLI - Manual (Page 23)

General Network Management Commands
XSR CLI Reference Guide 1-9
Reply from 192.168.27.165: 10ms
Reply from 192.168.27.165: 10ms
Reply from 192.168.27.165: 10ms
Reply from 192.168.27.165: 10ms
Packets: Sent = 5, Received = 5, Lost = 0
The following example shows the destination lost after three pings:
XSR>ping 134.141.235.165
Reply from 134.141.235.165: 20ms
Reply from 134.141.235.165: 10ms
Reply from 134.141.235.165: 10ms
Timeout
Timeout
Packets: Sent = 5, Received = 3, Lost = 2
privilege
This command modifies the username privilege level associated with a particular CLI
configuration mode. You can also associate a privilege level with another command or group of
commands. The modes which can be set include the following:
• class-map
• configure (global)
• controller
• exec
• interface-dialer
• interface-dlci
• interface-fastEthernet
• interface-loopback
• interface-serial
• map-class-dialer
• map-class-frame-relay
• policy-map
• policy-map-class
• router-ospf
• router-rip
• subinterface
This command is used in conjunction with the username command to set the privilege level for a
user. The show running-config command displays user information.
Syntax
privilege operationMode {level value | reset} {command | commandgroup}
privilege Associates privilege level with a command.
operationMode Configuration mode associated with privilege level.