Enterasys Networks X-Pedition XSR CLI User Manual
Page 515
Other ADSL Commands
XSR CLI Reference Guide 13-89
•
backup
‐ configures and enables a backup interface for the ATM sub‐interface. Refer to
•
crypto
‐ enables and configures VPN parameters on the sub‐interface. Refer to
the command description.
•
description
‐ adds a description string to an existing ATM sub‐interface. Refer to
for the command description.
•
encapsulation
‐ selects the data encapsulation method for this ATM sub‐interface. Refer to
•
exit
‐ quits ATM Sub‐Interface mode and returns to Global mode. Refer to
command description.
•
ip address
‐ specifies the IP address and subnet mask of the ATM sub‐interface or requests
the IP address and subnet mask be negotiated. Refer to
description.
•
no shutdown
‐ sets the ATM sub‐interface to the administrative up state and enables the
virtual circuit. Refer to
•
oam-pvc
‐ enables end‐to‐end F5 (circuit) OAM cell procedures for ATM Permanent Virtual
Circuit (PVC) management. Refer to
for the command description.
•
oam-retry
‐ configures parameters related to OAM cell handling for ATM VC management.
Refer to
for the command description.
•
pvc
‐ sets the sub‐interface circuit type to PVC and specifies ATM VPI/VCI values. Refer to
•
shutdown
‐ sets the ATM sub‐interface to the administrative Down state halting all data traffic
Syntax
interface atm {slot/card/port.sub-interface}[point-to-point]
Syntax of the “no” Form
The no form of this command deletes the sub‐interface object:
no interface atm [slot/]card/port.sub-interface [point-to-point]
Mode
Global configuration:
XSR(config)#
Next Mode
ATM Sub‐Interface configuration:
XSR(config-if<ATMxx.x>)#
slot
The XSR slot number, ranging from 0 to 2.
card
The XSR NIM number, ranging from 1 to 2.
port
The XSR slot number: 0.
sub-interface
Identifies a sub‐interface on that interface, ranging from 1 to 30.
point-to-point
Interoperability option.