Enterasys Networks X-Pedition XSR CLI - Manual (Page 400)

Multilink Show Commands
8-130 Configuring the Point-to-Point Protocol
Rx Stats
Tx Stats
show ppp interface multilink/dialer memberlink
This command displays general member link statistics under MLPPP or specific member link
statistics if specified.
Syntax
show ppp interface multilink <1-32767> memberlink [type number]
show ppp interface dialer <1-256> memberlink [type number]
Parameters
Mode
EXEC: XSR>
Sample Output
The following example displays output of this command:
********** MLPPP Member Link Stats **********
Multilink 1: MLPPP is Admin Up / Oper Up
Group Num: 1
LCP State:
OPENED
Total Sum of fragments received for this class.
Discard Seq
Error Sum of received fragments discarded for this class because sequence number is
out of order.
FlistFull Sum of received fragments discarded for this class because fragment list is full.
Seq<Exp Sum of received fragment discarded for this class because sequence number is
less than expected.
NoBgnFlg Sum of received fragments discarded for this class because no BEGIN flag
detected.
AddFgFail Sum of received fragments discarded for this class because fragment cannot be
added into fragment list.
CleanQ Sum of received fragments discarded for this class while cleaning the interface.
Total Sum of fragments transmitted for this class.
Discard CleanQ Sum of transmission fragments discarded for this class while cleaning port.
Qfull Sum of transmission fragments discarded for this class because transmission
queue is full.
type Interface type serial. If serial is specified, only this serial member link statistics
display, otherwise all member link data display.
number Card/port numbers for a serial interface. Card/port:channel numbers for serial
channel groups.