Enterasys Networks X-Pedition XSR CLI - Manual (Page 416)

Frame Relay Commands
9-92 Configuring Frame Relay
Mode
Interface configuration: XSR(config-if<xx>)#
Example
This example sets the LMI failure threshold to 5 for the DCE device:
XSR(config)#interface serial 1/0
XSR(config-if<S1/0>)#encapsulation frame-relay
XSR(config-if<S1/0>)#frame-relay intf-type dce
XSR(config-if<S1/0>)#frame-relay lmi-n392dce 5
frame-relay lmi-n393dce
This command sets the monitored event count on a Data Communications Equipment (DCE)
interface.
Syntax
frame-relay lmi-n393dce events
Syntax of the “no” Form
The no form of this command removes the current setting:
no frame-relay lmi-n393dce
Default
4
Mode
Interface configuration: XSR(config-if<xx>)#
Example
This example sets the LMI monitored events count to 10 on serial port 1/0:
XSR(config)#interface serial 1/0
XSR(config-if<S1/0>)#encapsulation frame-relay
XSR(config-if<S1/0>)#frame-relay lmi-n393dce 10
events Value of monitored events count ranging from 1 to 10.