Enterasys Networks X-Pedition XSR CLI - Manual (Page 233)

Other IP Commands
XSR CLI Reference Guide 5-157
Syntax of the “no” Form
The no form of this command removes a UDP port or UDP protocol. If the UDP protocol is
removed, UDP forwarding is disabled.
no ip forward-protocol {udp [port]}
Mode
Global configuration: XSR(config)#
Defaults
Enabled, but no port specified. This acts as a BOOTP forwarding agent. The above list of ports is
used by default for forwarding.
Examples
The following example, as shown in Figure 5‐6 , forwards UDP traffic to a router across the
Internet:
XSR(config)#ip forward-protocol udp
XSR(config)#interface fastethernet 1
XSR(config-if<F1>)#ip helper-address 196.1.1.255
This example removes DNS from the list of ports for which UDP broadcast forwarding is done:
XSR(config)#no ip forward-protocol udp 53
Figure 5-6 IP Forward-Protocol Example
port Destination port that controls which UDP services are forwarded. If not
set, forwarding is done on the following default ports:
• Trivial File Transfer Protocol (TFTP) (port 69)
• Domain Naming System (port 53)
• Time service (port 37)
• NetBIOS Name Server (port 137)
• NetBIOS Datagram Server (port 138)
• Boot Protocol (BTP) client and server datagrams (ports 67, 68)
• TACACS service (port 49)
• IEN‐116 Name Service (port 42)
Router 2 196.1.1.0 Router 1
195.1.1.0
Host
Destination: 195.1.1.255
Global Configuration
ip forward-protocol UDP
interface ethernet 1
ip helper-address 196.1.1.255
1
2
eth 1
INTERNET