Enterasys Networks X-Pedition XSR CLI - Manual (Page 680)

Firewall Show Commands
16-136 Configuring Security
Sample Output
The output below displays network objects for the Private‐network and Partner‐networks groups.
Note that only member objects names are shown.
You can enter the show ip firewall network command to get address ranges of each network
object.
Name Network (group) objects
Private-network internet
Remote-access 10.1.0.0/16
Partner-networks dmz
ext192
ext253
ext254
int int40
show ip firewall service
This static counter displays all configured service objects. It includes three versions:
• Show ip firewall service ‐ Displays all services, pre‐defined and user‐defined.
• Show ip firewall user-defined ‐ Displays user‐defined services only.
• Show ip firewall service name ‐ Displays a specific service object identified by name.
Syntax
show ip firewall service [user-defined | name]
Mode
EXEC or Privileged EXEC Mode: XSR> or XSR#
Sample Output
The following output displays firewall service objects:
Name Source port range Destination port range Protocol
ftp 1024-65535 21-21 tcp
netbios 137-137 137-137 udp
show ip firewall service-group
This static counter displays all service group objects. If the optional service group name is
specified then only that service group object is displayed.
Syntax
show ip firewall service-group [name]
user-defined Lists user‐defined services only.
name Name of a service object.