Epson 800p - Manual (Page 38)

32 Using the Remote Control
Turning On and Using the Remote
Control
Before using the remote control, you need to install its batteries and
turn it on as described below.
Installing Batteries
Follow these steps to install or replace the batteries:
1. Press the tab to release the
battery compartment cover.
2. Remove the cover and insert
the two AA batteries included
with the projector as shown.
3. Replace the battery
compartment cover.
Turning On the Remote Control
Make sure batteries are installed. Then push up the on/off switch on
the side of the remote control to turn it on.
Turn off the remote control before transporting it or storing it in a
projector case. This prevents the batteries from discharging if
something presses against one of the buttons.
caution
When replacing batteries,
take the following
precautions:
■ Don’t mix old and new
batteries.
■ Replace batteries as soon as
they run out. If the batteries
leak, wipe away battery fluid
with a soft cloth. If fluid gets
on your hands, wash them
immediately.
■ Do not expose batteries to
heat or flame.
■ Dispose of used batteries
according to local regulations.
■ Remove batteries if you
won’t be using the projector
for a long period of time.
tab