Epson 800p - Manual (Page 79)

Solving Problems 73
If you’re using a PC laptop:
■ Hold down the Fn key and press the function key that lets you
display on an external monitor. It may have an icon such as
, or it may be labelled CRT/LCD . Allow a few seconds for
the projector to sync up after pressing it. Check your laptop’s
manual or online help for details.
On most systems, the key lets you toggle between the LCD
screen and the projector, or display on both at the same time.
■ Depending on your computer’s video card, you might need to use
the Display utility in the Control Panel to make sure that both the
LCD screen and external monitor port are enabled. See your
computer’s documentation or online help for details.
If you’re using a PowerBook:
1. From the Apple menu, select Control Panels , then click
Monitors and Sound .
2. Click the Arrange icon.
3. Drag one monitor icon on top of the other. This lets you
display on the projector screen as well as the LCD screen.
4. If this option isn’t available, click the Monitor icon.
5. Select one of the listed Simulscan resolutions. (Allow a few
seconds for the projector to sync up after making the
selection.)
The message Not Supported is displayed.
■ Make sure the Comp1 Input and Comp2/ YCbCr options in the
Setting menu are correct. See page 54.
■ Make sure your computer’s resolution doesn’t exceed UXGA
(1600
× 1200), and the frequency is supported by the projector
(see page 106). If necessary, change your computer’s resolution
setting as described on the following page.