Epson 800p - Manual (Page 89)

Appendix A: Connecting to Additional Equipment 83
Connecting to an External Audio System
The projector’s internal speakers are loud enough for most rooms.
However, if your installation requires maximum volume and sound
quality, you can connect the projector to external speakers or a public
address (PA) system. This disables the projector’s internal speakers.
If you’ve connected multiple audio and video sources to the projector,
the projector will automatically switch the audio along with the video
source whenever you choose a different video source. (See “Switching
Between Picture Sources” on page 28 or page 33.)
To connect the projector to an external sound system, you will need
an RCA-to-3.5 mm stereo audio cable, which may be included with
your sound system, or may be purchased from an electronics store.
Before you start, make sure the projector and speakers or PA system
are turned off.
1. Connect the cable’s 3.5-mm stereo miniplug to the projector’s
Audio Out jack.
2. Connect the RCA plugs on the opposite end of the cable to the
left and right jacks of your speaker or PA system.
Audio Out jack