HP 441877-00B User Manual
Page 119
Adapter configurations 119
o
This keyword is to enable the use of batching receives within a specific time period.
o
Min = 0, disabled
o
Max = 5000000, 5 seconds
o
Units are in micro seconds
o
Default = 360
•
TxPacketsPer=
o
This keyword is to enable the use of batching transmits to a specific amount of packets.
o
Min = 0, disabled
o
Max = 100
o
Default = 64
•
CheckSum=
o
This keyword is to enable or disable the transmit & receive checksum off loading feature. The
checksum off loading support is only for TCP/IP packets. For that reason, the default OFF.
o
Choices are: ON, OFF, TX, RX
o
Default is ON
•
TxFlow=
o
This keyword allows enabling/disabling of TxFlow control.
o
Choices are: ON, OFF
o
Default is OFF
•
RxFlow=
o
This keyword allows enabling/disabling of RxFlow control.
o
Choices are: ON, OFF
o
Default value is OFF
•
VLAN=
o
This keyword allows enabling/disabling of VLAN tagging support. This keyword is only used
when the QASP program is loaded for VLAN support on the Q57 driver. Do not set the VLAN
keyword to 1 if the QASP program is not being used.
o
Choices are: 0 (Disabled), 1 (Enabled)
o
Default value is 0
•
Jumbo=
o
This keyword enables Jumbo frame support. When enabled, jumbo packets of up to 9000 bytes
are supported.
o
Jumbo=1514-9000
o
Default is jumbo packets not supported.
•
PDriver=
o
This keyword allows for the driver to operate in persistent driver mode. Only use it if the adapter
is placed in a Hot Plug PCI slot and only if required to swap with an exact same board.
o
Choices are: ON, OFF
o
Default value is OFF