HP 441877-00B User Manual
Page 160
Diagnostics 160
This is an internal loopback data transmit/receive test. It initializes MAC into internal loopback
mode, and transmits 100 packets. The data should be routed back to the receive channel and is
received by the receive routine, which verifies the integrity of data. One Gigabit rate is used for this
test.
•
D2. Phy loopback test
This test is the same as D1. Mac Loopback Test except the data is routed back via physical layer
device. One Gigabit rate is used for this test.
•
D5. MII miscellaneous test (copper only)
This function tests the auto-polling and phy-interrupt capabilities. These are the functionalities of the
phy.
•
D6. MSI test
This tests the Testing Message Interrupt Function to see if it handles this interrupt correctly. The default
is disabled.
Starting the Q57DIAG.exe tests
1.
If you have not already done so, download and extract the HP SoftPaq file and then run
MAKEDISK.BAT
to create a driver disk.
2.
Boot to DOS or the EFI shell.
3.
From the DOS prompt or shell navigate to the \APPS\DIAGS\Q57 directory.
4.
Type
Q57DIAG.
exe and press the
Enter key. The diagnostic tests run automatically.
Command line options
The following are the available options in q57diag. They are case sensitive.
Usage: q57diag.exe [options]
•
-c <num>
o
Specifies UUT device number
When more than one device is in the system, the devices are numbered starting from zero. For
example, if there are three devices detected, the devices are numbered as 0, 1, and 2. In this
case, entering the parameter -c 2 will select the last found device as default UUT. In manufacture
testing mode, by default, all devices are tested; however, if this option is used, only that selected
device is tested.
o
Example: q57diag.exe -c 2
•
-smbaddr <num>-
o
Specifies the ASF SMBus Address
•
-h
o
Specifies high resolution (80x50) video mode
o
Example: q57diag.exe -h
•
-l <file>
o
Specifies the log file in which all diagnostic output is saved. The default is no log file.
o
Example: q57diag.exe -l mylogfile.txt
•
-p
o
Specifies Print on Error