HP 441877-00B - Manual (Page 166)

Diagnostics 166
5. Read only bit %s got changed after writing 1's at offset 0x%X
6. Read/Write bit %s did not get cleared after writing zero at offset 0x%X
7. Read/Write bit %s did not get set after writing 1's at offset 0x%X
8. BIST failed.
9. Could not generate interrupt
10. Test aborted by user
11. Tx DMA:Got 0x%08x @ 0x%08x. Expected 0x%08x
12. Rx DMA:Got 0x%08x @ 0x%08x. Expected 0x%08x
13. Tx DMA failed
14. Rx DMA failed
15. Data error, got 0x%08X at 0x%08X, expected 0x%08X
16. Second read error, got 0x%08X at 0x%08X, expected 0x%08X
17. Failed writing EEPROM at 0x%04X
18. Failed reading EEPROM at 0x%04X
19. EEPROM data error, got 0x08X at 0x04X, expected 0x%08X
20. Cannot open file %s
21. Invalid CPU image file %s
22. Invalid CPU image size %d
23. Cannot allocate memory
24. Cannot reset CPU
25. Cannot release CPU
26. CPU test failed
27. Invalid Test Address Range
Valid adapter address is 0x%08x-0x%08x and exclude 0x%08x-0x%08x
28. DMA:Got 0x%08x @ 0x%08x. Expected 0x%08x
29. Unsupported PhyId %04X:%04X
30. Too many registers specified in the file, max is %d
31. Cannot write to VPD memory
32. VPD data error, got %08X @ 0x04X, expected %08X
33. No good link! Check Loopback plug
34. Cannot TX Packet!
35. Requested to Tx %d. Only %d is transmitted
36. Expected %d packets. Only %d good packets are received
%d unknown packets have been received
%d bad packets have been received
37. %c%d is an invalid Test
38. EEPROM checksum error
39. Error in reading WOL/PXE
40. Error in writing WOL/PXE