HP 441877-00B - Manual (Page 164)

Diagnostics 164
• -firmall <file>
Updates device eeprom based on <file>; Only MAC address will be preserved
• -pxe
Programs PXE firmware from file
• -elog <file>
Produces a log file with only error information
• -dids
Shows PCI DID, VID, SDID, and SVID of present devices
• -pasf <file>
o Programs ASF firmware
o <file> is a text file that contains ASF bin file names
• -pxes <value>
o Sets PXE speed
o Value = 0 for auto; Value = 1 for 10HD; Value = 2 for 10FD; Value = 3 for 100HD; Value = 4
for 100FD; Value = 6 for 1000FD (fiber)
• -hlb <spd>
o Sets device host loopback mode
o spd = 10/100/1000
o dflt = 1000
• -tr <pkts> <spd>
o Sets Tx and Rx pkts packets
o dflt Tx pkts = 1e6
o spd = 10/100/1000
• -lbsped <spd>
o Runs D3 loopback test at <spd>
o spd = t/h/g => 10/100/1000
• -l200 <m200>
Runs D4 loopback test with 200*m200 packets
• -dispgbend
Runs D4 loopback test and displays packets at end
• -disppkts
Runs D4loopback test and displays packet count
• -errlimit <lim>
Runs D4 loopback test. Fail after errors greater than <lim>.
• -pktf0
Runs D4 loopback test. Packet Data Alternating F 0.
• -rsttm <x>
o <x> = 0 dis GRC rst. <x>!=0, post rst dly in ms