Hobart Welding Products AirForce 625 And ICE-40C Torch - Manual (Page 35)

OM-926 Page 31
211 120-A
For extended tip use, set Amperage control to 35.
Gouging
FAILURE TO REPLACE WORN TIP OR
ELECTRODE WILL RUIN TORCH AND
VOID WARRANTY.
S Turn off power before checking torch parts.
S Check before each use and hourly during operation.
CAUTION
ICE−40C
CONSUMABLES
NOTE:
Set air pressure to 75 PSI for cutting
or 55 PSI for gouging.
211 120−A
Drag Shield
204 323
Retaining Cup
192 050
Tip
204 325
Electrode
192 047
Swirl Ring
192 049
O−Ring
169 232
Deflector
177 888
Retaining Cup
192 050
35A Tip
192 052
Electrode
192 048
Shield
192 203
Retaining Cup
192 050
Tip
204 332
Electrode
192 047
Standard
Cutting
Extended
Cutting —1/8” (3 mm)
standd−off
recommended
Apply silicone
grease (169 231)
before installing.
Figure 8-3. Consumable Parts For ICE-40C
To maintain the factory original performance of your equipment, use only Manufacturer’s Suggested
Replacement Parts. Model and serial number required when ordering parts from your local distributor.