HP 20/700 - Manual (Page 117)

116 Operating in Automated Mode Chapter 4
Running Drive Diagnostic Tests
To run a diagnostic test on a drive:
1. Ensure the library is not in use.
2. Press
the [MENU] button until the Main Menu displays.
3. Press the arrow buttons until the cursor underscores DIAGNOSTICS.
4. Press the [SELECT] button.
The panel displays the Main Diagnostics Menu.
5. Press the arrow buttons until the cursor underscores DRIVE DIAGNOSTICS.
6. Press
the [SELECT] button.
The screen will display a list of installed drives.
7. Use the arrow buttons to highlight the desired drive.
8. Press the [SELECT] button.
The Diagnostics Drive Menu appears.
9. Press the arrow buttons until the cursor underscores the desired test. For a
description of the available tests, see Table 12 on page 115.
10. Press the [SELECT] button.
If you selected MOUNT/DISMOUNT LOOP, an editing screen will appear:
a. Use the arrow buttons to enter the desired value. (The up arrow button
increases the value; the down arrow button decreases the value.)
b. Press the [SELECT] button.
11. You will be prompted to confirm that you want the library in Maintenance
Mode (offline) before beginning the test (ARE YOU SURE?). Confirm this
by pressing the [SELECT] button. (You may press the [MENU] button to
abort.)
12. Wait until the test is completed; the screen will display a message that
either the test completed successfully or, if a problem occurred, the screen
will display an error message and, in some cases, an FSC code.