HP 20/700 - Manual (Page 133)

132 Manual Operation Chapter 4
To load a cartridge into a DLT drive:
1. Open the tape library right front door by pulling on the left side of the
door.
2. Open the library left front door by using a latch key to unlock both locks.
See Figure 32 on page 123. Turn the key counter clockwise to unlock
them, then pull open the door.
3. Locate the cartridge (see Locating a Cartridge in the Storage Cells on
page 127).
4. Make sure the DLT handle is up (see Figure 37 on page 133) and the
Operate Handle indicator is steadily on.
Note If the handle is in the down position, wait for the Operate
Handle indicator to remain on steadily before moving it to the
up position (see Figure 37 on page 133). If the Operate Handle
indicator is flashing while the handle is up, move the handle to
the down position and wait for the Operate Handle indicator to
remain on steadily. Then move the handle to the up position.