HP 20/700 - Manual (Page 36)

Chapter 2 Operator Panel 35
Chapter 2
Use the operator panel to:
■ Monitor current information about the CAPs, configuration, drives, doors,
drive cleaning, hardware and software versions, personality, and library
status
■ Help resolve library problems
■ If an error occurs, the display shows a fault symptom code (FSC), which
you can give to a service representative to help resolve problems. Write
down the FSC as soon as it is displayed.
■ Set library, network, and drive configurations
■ Rotate the CAPs
■ Replace drive cleaning cartridges and set cleaning cartridge warning
count
■ Run library and drive tests
■ Reset the library (start an initial program load [IPL])
For specific task instructions, refer to Configuration on page 65 and Library
Operation on page 93.