HP 20/700 - Manual (Page 41)

40 Operator Panel Chapter 2
Except for CAP status and error or FSC information, these values are set
through an automatic configuration process that occurs during an IPL.
Values requiring your input are:
■ Cleaning cartridge warning count
■ SCSI drive configuration:
— SCSI ID
— Bus status (on or off bus)
■ Network configuration:
— Library name
— IP address
— Subnet mask
— Library gateway
■ Library configuration information:
— SCSI ID
— Fast Load enable/disable
— Date/time
■ Display screen brightness and contrast
You can also use the menus to run diagnostic tests.
The following pages describe the library’s primary menus. For instructions on
working with specific configuration values, see Operator Panel Entry on
page 70.